p≡p engine FORK
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.

2.8 KiB

Build instructions for Debian 9

Installing packaged dependencies

# general
apt install -y mercurial
# YML2
apt install -y python-lxml
# libetpan
apt install -y git build-essential automake libtool
# asn1c
apt install -y git build-essential automake libtool autoconf
# engine
apt install -y uuid-dev libgpgme-dev libsqlite3-dev sqlite3

Installing unpackaged dependencies


mkdir -p ~/code/yml2
hg clone https://pep.foundation/dev/repos/yml2/ ~/code/yml2


pEp Engine requires libetpan with a set of patches that have not been upstreamed yet.

mkdir -p ~/code/libetpan
git clone https://github.com/fdik/libetpan ~/code/libetpan
cd ~/code/libetpan
mkdir ~/code/libetpan/build
./autogen.sh --prefix="$HOME/code/libetpan/build"
make install


mkdir -p ~/code/asn1c
git clone git://github.com/vlm/asn1c.git ~/code/asn1c
cd ~/code/asn1c
git checkout tags/v0.9.28 -b pep-engine
autoreconf -iv
mkdir ~/code/asn1c/build
./configure --prefix="$HOME/code/asn1c/build"
make install

pEp Engine

mkdir -p ~/code/pep-engine
hg clone https://pep.foundation/dev/repos/pEpEngine/ ~/code/pep-engine
cd ~/code/pep-engine
mkdir ~/code/pep-engine/build

Edit the build configuration to your needs in Makefile.conf, or create a local.conf that sets any of the make variables documented in Makefile.conf. All the default values for the build configuration variables on each platform are documented in Makefile.conf.

If a dependency is not found in your system's default include or library paths, you will have to specify the according paths in a make variable. Typically, this has to be done at least for YML2, libetpan and asn1c.

For a more detailed explanation of the mechanics of these build configuration files, and overriding defaults, see the comments in Makefile.conf.

Below is a sample ./local.conf file, for orientation.





The engine is built as follows:

make all
make db

The unit tests can be run without the engine library being installed, however system.db must be installed:

make -C db install

Since system.db rarely changes, its installation is not needed for every build.

Tests can be compiled and executed with the following commands:

make -C test compile
make test